MIROTHANE PU 5650 Pigmented Topcoat

Code: 5650

A premium, two pack, fast cure polyurethane topcoat that has been formulated to have superior resistance to water, general household contaminants, marring and scuffing. Available in a full range of gloss levels.

Features

Features

  • Available in an extensive colour range or tintable to a colour sample
  • Excellent flow and levelling results in a smooth even finish
  • With the application of the recommended undercoat or primer may be applied over wood, MDF, melamine, glass, metal and plastic

 

Specifications

Specifications

Colour : White & Tinted Colours
Finish : Satin (30%), Semi Gloss (60%) & Full Gloss
Build : Very Good
Sandability : Good
Vertical Hold Up : Good
Solvent Resistance : Excellent
Water Resistance : Excellent
Levelling & Flow : Excellent
Sink Back : Minimal
Coverage : 8m2 per litre at 125 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1222 or 1286 Thinner
Packaging : 1-16L

 

Tech Data Sheet

Application

Application

Mixing Ratio (by volume) : Refer to Technical Data Sheet.
Pot Life : Satin & Semi Gloss: > 8 hours Full Gloss: 2 – 8 hours Pot life varies significantly with ambient temperature, humidity and the quantity mixed. Pot life is longer at lower temperatures and shorter at higher temperatures. The larger the quantity mixed, the shorter the pot life will be. Only mix the quantity required for the job.
Thinning : Satin & Semi Gloss – Thin 40-55% with MIROSOL 1217 (Fast), 1263 (Medium), 1266, 1218 (Slow) when using high solids Part B. When using Ready For Use (RFU) Part B’s thin 30-40%. Full Gloss – thin up to 25% with MIROSOL 1263 (Medium), 1260, 1266, 1218 (Slow) when using high solids Part B. When using RFU Part B’s thin 20-30%. MIROSOL 1281 Matt Promoter may be added to MIROTHANE PU 5650 Satin at an addition rate of 30-40% to achieve an approximate gloss level of 10-15%. In order to maintain consistency of colour and gloss during a job or repeat jobs of the same colour, it is critical to use the same Part B Hardener and thinner throughout. To speed up dry time add up to 3% MIROTHANE PU 5795 Accelerator.

 

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

 

Where to Use

Where to Use

Interior use. Interior doors, kitchen & bathroom cabinets, commercial joinery and wall panelling and domestic furniture. With the appropriate primers may be used to topcoat glass, plastic and metal.

To top