MIROTHANE PU 5605 Pigmented Topcoat

• Superior chemical and moisture resistance
• The high build will enhance the finished appearance of the topcoat by filling and covering the fires of the substrate
• Excellent flow and levelling results in a smooth even finish with excellent distinction of image (DOI)

Colour : White & tinted colours
Finish : Full Gloss
Build : Excellent
Sandability : Good
Vertical Hold Up : Good
Solvent Resistance : Excellent
Water Resistance : Excellent
Levelling & Flow : Excellent
Sink Back : Minimal
Coverage : 10m2 per litre at 125 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1222 or 1286 Thinner
 

Data Sheet

Safety Data Sheets

Mirotone Warranty Information

Mixing Ratio (by volume) : Full Gloss: 1 Part 5605/FG Part A + 1 Part 5747 or 5780 Part B (1A:1B) or 2 Parts 5605/FG Part A + 1 Part 5757 or 5776 or 5784 or 5789 (2A:1B) Refer to Technical Data Sheet.
Pot Life : 2 hours Pot life varies significantly with ambient temperature, humidity and the quantity mixed. Pot life is longer at lower temperatures and shorter at higher temperatures. The larger the quantity mixed, the shorter the pot life will be. Only mix the quantity required for the job.
Thinning : Thin 20-40% with MIROSOL 1217 (Fast), 1263 (Medium), 1266, 1218, 1260 (Slow). In order to maintain consistency of colour during a job or repeat jobs of the same colour, it is critical to use the same Part B Hardener and thinner throughout.

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).
Curtain Coater - Viscosity 40 – 50 seconds. Consult your local representative for further information.

Interior use. Doors, kitchen & bathroom cabinets, commercial joinery, wall panelling and domestic furniture. With the appropriate primers it may be used to topcoat glass, plastic and metal.