Call Us:1-300-132-202

MIROTHANE PU 5600 Pigmented Undercoat

MIROTHANE PU 5600  is a user friendly, two pack pigmented, polyurethane undercoat that provides an excellent base of polyurethane topcoats. Fast drying and high build ensures excellent productivity for the user.

  • High build enhances the finished appearance of the topcoat
  • Easy to sand, results in minimal sanding time
  • Use up left over MIROTHANE PU 5650 topcoat by adding it to MIROTHANE PU 5600 undercoat to create your own tinted undercoat
  • Maybe topcoated with MIROTHANE PU polyurethane and MIROBILD AC acid catalysed topcoats
Colour
White
Finish
NA
Build
Good
Sandability
Excellent
Vertical Hold Up
Good
Solvent Resistance
Excellent
Water Resistance
Excellent
Levelling & Flow
Good
Sink Back
Minimal
Coverage
6-7m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time
Refer to Technical Data Sheet
Clean Up
Clean all equipment using MIROSOL 1222 or 1286 Thinner
Packaging
20L
Product Code
5600-A-0001-20
  1. Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
  2. Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
  3. Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
  4. Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).
  • Interior use. Doors, kitchen & bathroom cabinets, commercial joinery and wall panelling and domestic furniture.