MIROTHANE PU 5555 Clear Topcoat

• Excellent water and chemical resistance makes it ideal for demanding in-service environment  such as marine fit-outs, bench tops and bar tops
• Very low yellowing, it is suitable for use over light coloured wood and veneers when mixed with a low yellowing MIROTHANE PU Part B Hardener
• The full gloss version results in a brilliant high gloss finish with excellent distinction of image (DOI).
• Available in satin, semi gloss and full gloss
• Biomaster Antimicrobial ISO 22196 accredited formulation available

Colour : Clear
Finish : Satin (30%), Semi Gloss (60%) & Full Gloss
Build : Very Good
Sandability : Excellent
Vertical Hold Up : Good: Excellent
Water Resistance : Excellent
Levelling & Flow : Excellent
Sink Back : Minimal
Coverage : 6m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1222 or 1286 Thinner
 

Data Sheet

Safety Data Sheets

Mirotone Warranty Information

Mixing Ratio (by volume) : Refer to datasheet for mixing ratios
Pot Life : 2-3 hours at 25°C Pot life varies significantly with ambient temperature, humdity and the quantity mixed. Pot life is longer at lower temperatures and shorter at higher temperatures. The larger the quantity mixed, the shorter the pot life will be. Only mix the quantity required for the job.
Thinning : Refer to datasheet for thinning
 

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Interior use only. Ideal for demanding environments such as bar, kitchen bench tops, bathroom vanities, interior marine fit-outs and commercial fit outs.