Call Us:1-300-132-202

MIROTHANE PU 5500 Clear Isolator Coat

MIROTHANE PU 5500 is a versatile clear isolator that, depending upon the requirements, may be applied as either a single pack or two pack primer.

MIROTHANE PU 5500 minimises the risk or resin exudation and tannin bleed when applied as a first primer coat on bare wood. It minimises the risk of edge cracking on MDF. It minimises sick back to provide maximum hold up for subsequent coats of MIROPOL PE or MIROTHANE PU Sealers or undercoats.

To achieve the best adhesion, tannin blocking performance and hold up of subsequent coats, application of MIROTHANE PU 5500 as a two pack product is recommended.

  • Fast drying
  • No sanding required
  • Water white, excellent clarity
  • Excellent adhesion to wood, MDF & LPM
Colour
Clear
Finish
NA
Build
Low
Sandability
NA
Vertical Hold Up
Good
Solvent Resistance
Good
Water Resistance
Excellent
Levelling & Flow
Excellent
Sink Back
Minimal
Coverage
10m2 per litre at 100 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time
Refer to Technical Data Sheet
Clean Up
Clean all equipment using MIROSOL 1222 or 1286 Thinner
Packaging
4L & 20L
Product Code
5500-A
  1. Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
  2. Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
  3. Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
  4. Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).
  • Tannin blocking primer under MIROTEC WB water based coatings, mouldings, picture frames, MDF furniture and fixtures, MDF routed grooves and solid Jarrah furniture and articles.