Call Us:1-300-132-202

MIROTEC WB 8060 Clear Topcoat

MIROTEC WB 8060 is a clear, single pack, water based topcoat. It is easy to apply and low yellowing.

  • Single pack, no pot life issues to manage and less waste of product
  • Water white and low yellowing, it is ideal for use over blonde timbers and liming stains
  • To minimise the risk of sink back and tannin bleed and achieve the best possible water and chemical resistance, apply MIROTHANE PU 5500 Clear Isolator mixed 10A:1B with MIROTHANE PU 5789 Hardener, as a first coat on bare wood
  • Higher solids content than clear nitrocellulose and precatalysed lacquers with similar chemical resistance to clear precatalysed lacquers.
  • Low VOC (solvent content), non-flammable, low odour, safer for workers and the environment
  • Formaldehyde free, zero formaldehyde emissions in rooms in which coated articles are installed or used
  • Isocyanate free, does not require air assisted face masks or other respiratory personal protective equipment for application
  • Phthalate free, it is ideal for children’s toys
  • Complies with the Green Building Council Australia: Green Star – Office Design v3 & Office As Built, Table IEQ-13.1 Maximum TVOC Content Limits for Paints, Varnishes and Protective Coatings
Colour
Water white
Finish
Matt (10%), Satin (30%) & Semi Gloss (60%)
Build
Good
Sandability
Excellent
Vertical Hold Up
Very Good
Solvent Resistance
Good
Water Resistance
Good
Levelling & Flow
Excellent
Sink Back
Minimal
Coverage
7m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time
Refer to Technical Data Sheet
Clean Up
Clean all equipment with water following use. Refer to Techical Data Sheet for further information
Packaging
5L & 20L
Product Code
8060-1 (10% Matt) 8060-3 (30% Satin) 8060-6 (60% Semi Gloss)
  1. Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
  2. Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
  3. Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
  4. Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).
  • Interior use only. Ideal for domestic and commercial furniture, children’s toys and furniture, picture frames, musical instruments, joinery and antique restoration.