MIROTEC WB 8052 Clear Polyurethane Water Based Topcoat

• Excellent chemical and abrasion resistance
• Single pack, no pot life issues to manage and less waste of product
• To minimise the risk of sink back and tannin bleed and achieve the best possible water and chemical resistance, apply MIROTHANE PU 5500 Clear Isolator mixed with MIROTHANE PU 5789 Hardener, as a first coat on bare wood
• Low VOC (solvent content), non-flammable , low odour, safer for workers and the environment
• Formaldehyde free, zero formaldehyde emissions in rooms in which coated articles are installed or used
• Isocyanate free, does not require air assisted face masks or other respiratory personal protective equipment for application
• Phthalate free, it is ideal for children’s toys

Colour : Clear (milky in can, dries clear)
Finish : Matt (10%), Satin (30%), Semi Gloss (60%)
Build : Good
Sandability : Excellent
Vertical Hold Up : Good
Solvent Resistance : Excellent
Water Resistance : Excellent
Levelling & Flow : Excellent
Sink Back : Minimal
Coverage : 8m2 per litre at 125 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment with water following use
 

Data Sheet

Safety Data Sheets

Mirotone Warranty Information

Thinning : Supplied ready for use (RFU). However if required, it may be thinned with up to 10% water depending upon application requirements. Note: only thin the volume of MIROTEC WB 8052 required for the job at hand. Once thinned the viscosity will continue to fall during the next 24 hours. If the application viscosity is too low, mix with some unthinned MIROTEC WB 8052 to bring the viscosity back up to the target.

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Interior use only. Ideal for domestic and commercial furniture, bar and table tops, bathroom vanities, stairs and handrails, window furnishing (venetian blinds and shutters), internal doors, wall panelling, nursery furniture and children’s toys, interior wooden articles e.g. picture frames, musical instruments. Due care must be taken in harsh in-service environments as coatings can be damaged by sharp objects & high heat. Use placemats, coasters, table cloths and other protective coverings to prevent damage.