Call Us:1-300-132-202

MIROPOL PE 5111 White Undercoat

MIROPOL PE 5111 is a premium, high build, white polyester undercoat for MDF and particleboard. When top coated with one of Mirotone’s full gloss polyurethane topcoats, it provides the ideal base to achieve the “wet look” European finish.

  • Excellent build and excellent flow and levelling results in high distinction of image (DOI) when top coated with a full gloss polyurethane topcoat
  • Superior vertical hold up makes it easy to apply high film weights without sags and runs
  • Excellent opacity, especially over sharp edges
  • Slight sheen allows operators to easily see where they have sanded
  • May be ordered as a two-pack with the cobalt pre added
Colour
White
Specific Gravity
1.43
Build
Excellent
Sandability
Excellent
Vertical Hold Up
Excellent
Solvent Resistance
Very Good
Water Resistance
Very Good
Levelling & Flow
Excellent
Sink Back
Minimal
Coverage
3m2 per litre at 300 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time
Refer to Technical Data Sheet
Clean Up
Clean all equipment using MIROSOL 1208 or 1234 Thinner
Packaging
25kg (17.49L) - Refer to Technical Data Sheet
Product Code
5111-A
  1. Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
  2. Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
  3. Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
  4. Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).
  • Interior use only. Interior doors, kitchen & bathroom cabinets, commercial joinery and wall panelling and domestic furniture.