MIROLAC NC 3130 White Undercoat

• Easy to sand, powders easily reducing sanding time
• Fast drying enables increased production throughput
• Minimises the risk of wax extraction when applied over MDF and HDF
• Single pack, no pot life issues to manage
• Formaldehyde free. safer for the applicator, zero formaldehyde emissions in rooms in which articles are installed
• Use up left over MIROLAC NC 3150 topcoat by adding MIROLAC NC 3130 to create your own tinted undercoats

Colour : White
Build : Good
Sandability : Good
Vertical Hold Up : Good
Solvent Resistance : Good
Water Resistance : Good
Levelling & Flow : Very Good
Sink Back : Minimal
Coverage : 6m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1222 or 1286 Thinner
 

Data Sheet

Safety Data Sheets

Mirotone Warranty Information

Thinning : Thin 25-40% with MIROSOL 1222 or 1220 (Fast), 1294 (Medium), 1242 (Slow).
 

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Interior use only. Ideal for domestic furniture, internal doors, children’s toys and furniture and built in wardrobes.