MIROCAT PC 3241 Clear Sealer

• High build provides improved hold up and reduces the number of coats required
• Easy to use, achieve an excellent finish with minimal effort
• Fast drying allows early sanding which minimises production time

Colour : Turbid in can, dries clear
Build : High
Sandability : Excellent
Vertical Hold Up : Very Good
Solvent Resistance : Good
Water Resistance : Good
Levelling & Flow : Excellent
Sink Back : Minimal
Coverage : 6m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data sheet
Clean Up : Clean all equipment using MIROSOL 1222 or 1286 Thinner
 

Data Sheet

Safety Data Sheets

Mirotone Warranty Information

Thinning : Thin up to 10% with MIROSOL 1222 or 1220 (Fast), 1294 (Medium), 1242 (Slow).

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Interior use only. Ideal for domestic furniture, children’s toys and furniture, picture frames, musical instruments, joinery and antique restoration.