Call Us:1-300-132-202

MIROBILD AC 3606 Clear Spray Topcoat

A low odour, low formaldehyde, isocyanate free clear acid catalysed topcoat suitable for interior wood. The long pot life makes MIROBILD AC 3606 ideally suited to automatic line operations.

  • Fast drying rate and long pot life make it ideal for automatic line operations
  • Results in a tough resilient film that protects quality furniture and fittings.
  • High build, provides maximum build with the minimum number of coats applied
  • Low yellowing, ideally suited for application over blond timbers and liming stains
  • Low formaldehyde, provides a safer working environment for persons applying the coatings, and compared to conventional acid catalysed coatings, superior in-service air quality around the coated article.
Colour
Clear
Finish
Matt (10%), Satin (30%), Semi Gloss (60%) & Full Gloss
Build
Excellent
Sandability
Excellent
Vertical Hold Up
Excellent
Solvent Resistance
Good
Water Resistance
Excellent
Levelling & Flow
Excellent
Sink Back
Minimal
Coverage
6-7m2 per litre at 150 micron wet film build. This is dependent on the application equipment/gun set up and the article being coated
Dry Time
Refer to Technical Datasheet
Clean Up
Clean all equipment using MIROSOL 1222 or 1286 Thinner
Packaging
4L & 20L
Product Code
3606-1A (Matt) 3606-3A (Satin) 3606-6A (Semi Gloss) 3606-9A (Full Gloss)
  1. Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi)
  2. Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
  3. Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
  4. Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).
  5. Curtain Coating - Viscosity 40-50 seconds.
  • Interior use only. Domestic and commercial furniture, wall panelling, joinery and fixtures.