|
|
|
|
|
|
A Guide to Problem Solving - The Application of Interior Wood Coatings |
|
 Home/Group/English/PRODUCTS/Problem Solving Guide |
|
| Coating partially drying during application, leaving characteristic white "cob-web" trails being sprayed from the gun. | |
|
|
|
| Incorrect or too fast a thinner used to reduce the coating. | |
| Use only the correct MIROSOL thinner as specified on the relevant product data sheet. | |
|
|
| Thin coating to the recommended viscosity as per the instructions on the relevant product data sheet. | |
| Coating drying too fast in hot atmospheric conditions. | |
| Apply coatings during the cooler part of the day. Install temperature and humidity control equipment into the spray booth and drying rooms. | |
| Incorrect spray-gun set up with too much air pressure drying the coating as it leaves the fluid tip. | |
| Decrease air pressure. Contact you Mirotone representative for advice if the problem persists. | |
Back to Problem Solving Guide
| Disclaimer: The recommendations above are based on data from Mirotone’s own research and information from others whose work we believe to be reliable. Due to possible differences in actual application methods and conditions, users must satisfy themselves that the end result meets their requirements. | |
|
|
|
|
|
|
| |
|
|